AP Chemistry · Unit 9: Thermodynamics and Electrochemistry

9.9 Cell Potential and Free Energy

In this lesson

Essential Question

How does voltage tell us if a reaction is favored?

In Topic 9.8 we built galvanic and electrolytic cells. Now we put numbers on them. By the end of this lesson, you should be able to calculate the voltage of a cell, use it to decide whether the reaction is thermodynamically favored, and use it to find ΔG°.

Video lesson coming soon. In the meantime, read through the lesson below.

The Sign of E°cell

  • E°cell = cell voltage at standard conditions (1 M, 1 atm, usually 25 °C)
  • Its sign tells us if the reaction is favored
  • E°cell > 0: thermodynamically favored, runs on its own (galvanic cell)
  • E°cell < 0: unfavored, needs an applied voltage (electrolytic cell)

E°cell is the cell potential, the voltage of the cell. It measures how hard the cell pushes electrons through the wire, in volts. If it is positive, the redox reaction runs on its own and makes electricity. Older books call this “spontaneous,” but on the AP exam, say thermodynamically favored. If it is negative, the reaction only happens if an outside voltage bigger than the cell’s own voltage is applied.

Standard Reduction Potentials

  • Every half-reaction is written as a reduction
  • Higher E° → easier to reduce
Half-reactionE° (V)
Ag+(aq) + e− → Ag(s)+0.80
Cu2+(aq) + 2e− → Cu(s)+0.34
2H+(aq) + 2e− → H2(g)0.00
Ni2+(aq) + 2e− → Ni(s)−0.25
Zn2+(aq) + 2e− → Zn(s)−0.76
Al3+(aq) + 3e− → Al(s)−1.66
Mg2+(aq) + 2e− → Mg(s)−2.37

Every half-reaction in the table has electrons on the reactant side. The value next to it, E°, is the standard reduction potential: how much that species wants to gain electrons. Ag+ ions at the top pull strongly on electrons. Mg2+ ions at the bottom barely want them at all, which means magnesium metal gives up its electrons very easily. Hydrogen is set to exactly 0.00 V, and every other value is measured compared to hydrogen.

Exam tip: you will get a table like this on the AP exam. Different textbooks round a few of these values differently, so always use the table you are given.

Calculating E°cell

E°cell = E°cathode − E°anode

  • Use both reduction potentials as listed
  • The minus sign takes care of the oxidation
A vertical number line of reduction potentials with Cu2+/Cu at +0.34 V near the top, 0.00 V in the middle, and Zn2+/Zn at −0.76 V near the bottom. A red double arrow spanning from the copper value to the zinc value is labeled 1.10 V.

Reduction happens at the cathode and oxidation happens at the anode. Copy both values straight from the table and do not flip the sign of the anode yourself. The minus sign in the equation already does that, because the anode half-reaction is really running backward as an oxidation.

For the zinc and copper cell from Topic 9.8, copper is reduced (cathode, +0.34 V) and zinc is oxidized (anode, −0.76 V): E°cell = (+0.34 V) − (−0.76 V) = +1.10 V. On the number line, the cell potential is the distance between the two half-reactions. The bigger the gap, the bigger the voltage. For a galvanic cell, the half-reaction higher on the table is the cathode, so the answer is always positive.

Never Multiply E°

  • E° is in volts: 1 V = 1 J/C
  • Double the reaction: double the J and the C
  • J/C stays the same, so E° stays the same

Ag+ + e− → Ag, E° = +0.80 V

× 2: 2Ag+ + 2e− → 2Ag, E° = +0.80 V (not 1.60 V!)

A volt is a joule per coulomb, the energy carried by each coulomb of charge. It is like a price per item, not a total. Doubling the silver half-reaction moves twice as many electrons, so there is twice the energy, but there is also twice the charge. Twice the joules divided by twice the coulombs is the same number of joules per coulomb. Cell potential is an intensive property, like temperature or density. The coefficients matter for ΔG° (through n), but never for E°.

Exam tip: multiplying E° by a coefficient is the most common mistake in this topic.

Writing the Overall Reaction

  • Multiply so e− lost = e− gained
  • n = moles of e− transferred
  • Oxidation: Zn → Zn2+ + 2e− (2e− lost)
  • Reduction × 2: 2Ag+ + 2e− → 2Ag (2e− gained)
  • Overall: Zn + 2Ag+ → Zn2+ + 2Ag, so n = 2 mol e−

Every electron lost at the anode has to be gained at the cathode. Zinc loses 2 electrons, but each silver ion gains only 1, so the silver half-reaction is multiplied by 2. Add the half-reactions and cancel the electrons; no electrons are left in the overall equation. The number of moles of electrons canceled is n, the moles of electrons transferred, which is needed to calculate ΔG°.

Free Energy from E°

ΔG° = −nFE°

  • n = mol e− transferred
  • F = 96,485 C/mol e− (the Faraday constant, the charge on one mole of electrons)
  • E° in volts, where 1 V = 1 J/C

Multiply the units: (mol e−)(C/mol e−)(J/C) = J. Moles of electrons cancel, coulombs cancel, and you are left with joules (strictly, joules per mole of reaction as written). This equation is on the AP equation sheet.

Exam tip: ΔG° values are usually reported in kilojoules, so divide by 1000 at the end. Don’t forget this step, especially when you compare to ΔG° values from Topic 9.3.

Opposite Signs

E°cellΔG°Thermodynamically favored?
+ (positive)− (negative)Yes (galvanic)
− (negative)+ (positive)No, needs applied voltage

Because n and F are always positive, the negative sign in ΔG° = −nFE° flips the sign. ΔG° and E°cell always have opposite signs. A positive E°cell means a negative ΔG°, so the reaction is thermodynamically favored. A negative E°cell means a positive ΔG°, so the reaction needs an outside voltage to run, like in an electrolytic cell.

Exam tip: you can use either sign to justify whether a reaction is favored. A great justification mentions the sign of E°cell and connects it to the sign of ΔG°.

↑ Back to top


Worked Examples

Try each problem on your own first, then open the solution to check your work.

Example 1: Calculating E°cell

Calculate E°cell for a galvanic cell that runs this reaction: Cu(s) + 2Ag+(aq) → Cu2+(aq) + 2Ag(s)

Half-reactionE° (V)
Ag+(aq) + e− → Ag(s)+0.80
Cu2+(aq) + 2e− → Cu(s)+0.34
Show the solution
  1. Identify the electrodes: Cu → Cu2+ is oxidation, so copper is the anode. Ag+ → Ag is reduction, so silver is the cathode.
  2. Equation: E°cell = E°cathode − E°anode
  3. Substitute: E°cell = (+0.80 V) − (+0.34 V). Use the values straight from the table. Do not multiply 0.80 by 2 for the 2 in front of Ag+, because E° does not depend on the coefficients.
  4. Answer: E°cell = +0.46 V. Both values go to the hundredths place, so the answer does too. It is positive, which makes sense for a galvanic cell.

Example 2: Finding n

How many moles of electrons (n) are transferred in this reaction?

2MnO4− + 16H+ + 10Cl− → 2Mn2+ + 5Cl2 + 8H2O

Show the solution
  1. Oxidation numbers: In MnO4−, oxygen is −2, so Mn is +7, and it ends as +2 in Mn2+. Cl starts at −1 in Cl− and ends at 0 in Cl2.
  2. Electrons gained: Each Mn goes from +7 to +2, gaining 5 e−. 2 Mn × 5 e− = 10 e− gained.
  3. Electrons lost: Each Cl goes from −1 to 0, losing 1 e−. 10 Cl × 1 e− = 10 e− lost. Electrons lost equals electrons gained, a good check that the equation is balanced.
  4. Answer: n = 10 mol e−. n is the total for the balanced equation, not the 5 electrons for one Mn or the 2 electrons for one Cl2.

Example 3: Calculating ΔG°

This cell has E°cell = +1.41 V. Calculate ΔG° in kJ/molrxn. (F = 96,485 C/mol e−)

2Al(s) + 3Ni2+(aq) → 2Al3+(aq) + 3Ni(s)

Show the solution
  1. Find n: 2Al → 2Al3+ + 6e− and 3Ni2+ + 6e− → 3Ni. Each Al loses 3 e− and there are 2 Al, so 6 e− are lost; each Ni2+ gains 2 e− and there are 3, so 6 e− are gained. n = 6 mol e−.
  2. Equation: ΔG° = −nFE°
  3. Substitute: ΔG° = −(6 mol e−)(96,485 C/mol e−)(1.41 J/C). Writing 1.41 V as 1.41 J/C lets moles of electrons and coulombs cancel.
  4. Multiply: ΔG° = −816,263 J
  5. Convert to kJ: −816,263 J × (1 kJ / 1000 J) = −816.263 kJ
  6. Answer: ΔG° = −816 kJ/molrxn (3 significant figures, from 1.41 V). It is negative, which matches the positive cell potential, so the reaction is thermodynamically favored.

Example 4: Is It Favored?

Is this reaction thermodynamically favored under standard conditions? Justify your answer.

Ni(s) + Mg2+(aq) → Ni2+(aq) + Mg(s)

Half-reactionE° (V)
Ni2+(aq) + 2e− → Ni(s)−0.25
Mg2+(aq) + 2e− → Mg(s)−2.37
Show the solution
  1. Read the reaction as written: Ni → Ni2+ is oxidation, so nickel is the anode. Mg2+ → Mg is reduction, so magnesium is the cathode.
  2. Substitute: E°cell = E°cathode − E°anode = (−2.37 V) − (−0.25 V). Watch the double negative.
  3. Calculate: E°cell = −2.12 V
  4. Connect to ΔG°: E°cell < 0, so ΔG° = −nFE° > 0.
  5. Answer: Not thermodynamically favored.

Sample exam justification: The reaction is not thermodynamically favored because E°cell = −2.12 V, which makes ΔG° positive. Mg2+ has a much lower reduction potential than Ni2+, so it does not take electrons from nickel on its own. This reaction would need an applied voltage, so it could only run in an electrolytic cell.

↑ Back to top


Practice

Check Your E°cell in the Electrochemistry Cell Builder

Pick two of zinc, copper and silver, predict which one is the cathode, and calculate E°cell = E°cathode − E°anode. Then build the cell and compare your answer with the voltmeter. In electrolytic mode, the cell only runs once the applied voltage is larger than the size of E°cell.

Lab worksheet: PDF | Answer key: PDF

Practice with instant feedback

Answer original AP-style questions for Unit 9 and see an explanation right after each one. Choose Topic 9.9 or mix topics. No login needed.

↑ Back to top


Lesson Slides

↑ Back to top


Big Ideas

  • E°cell = E°cathode − E°anode.
  • Never multiply E° by coefficients.
  • ΔG° = −nFE°, then convert J → kJ.
  • E° > 0 and ΔG° < 0: favored.
  • E° < 0 and ΔG° > 0: unfavored.

Back to the essential question: voltage tells us whether a reaction is favored, and with n and F, it tells us ΔG°. A positive cell potential means a negative ΔG°, so the reaction is thermodynamically favored. A negative cell potential means a positive ΔG°, so the reaction needs an applied voltage. Next up, Topic 9.10 looks at what happens to the cell potential when the concentrations are not standard.

↑ Back to top


AP Alignment

This lesson covers Topic 9.9, Cell Potential and Free Energy, in Unit 9 (Thermodynamics and Electrochemistry) of the College Board AP Chemistry Course and Exam Description (CED). Learning objective:

  • 9.9.A: Explain whether an electrochemical cell is thermodynamically favored, based on its standard cell potential and the constituent half-reactions within the cell.

Essential knowledge: 9.9.A.1, 9.9.A.2, 9.9.A.3

Suggested skill: 5.F Mathematical Routines. Calculate, estimate, or predict an unknown quantity from known quantities by selecting and following a logical computational pathway and attending to precision (e.g., performing dimensional analysis and attending to significant figures).

↑ Back to top