AP Chemistry · Unit 3: Properties of Substances and Mixtures

3.11 Spectroscopy and the Electromagnetic Spectrum

Essential Question

What can light tell us about molecules?

By the end of this lesson, you should be able to order the regions of the electromagnetic spectrum by energy and explain what kind of change microwave, infrared, and UV/visible radiation cause in a molecule.

Video not loading? Watch it on YouTube.

What Is Spectroscopy?

  • Spectroscopy is the study of how matter absorbs or emits light.
  • Light passes through a sample, and a detector measures what comes out the other side.
  • Which wavelengths are absorbed, and how much, tells us about the particles in the sample.
Spectroscopy setup: light from a light source passes through a sample to a detector. The wave leaving the sample is smaller than the wave entering it because some light is absorbed.

The wave leaving the sample is smaller than the wave going in because some of the light was absorbed. Spectroscopy uses light to learn about particles that are far too small to see.

The Electromagnetic Spectrum

  • Radio waves, microwaves, infrared, visible light, ultraviolet, X-rays, and gamma rays are all electromagnetic radiation.
  • The only difference between them is the wavelength.
  • Visible light is just a small slice of the full spectrum.
The electromagnetic spectrum from left to right: radio, microwave, infrared, visible, ultraviolet, X-ray, gamma ray. A wave below gets shorter from left to right. Arrows show frequency and energy increasing to the right and wavelength increasing to the left.

From radio to gamma, the wavelength gets shorter while the frequency and energy go up. You do not need to memorize exact wavelengths for this topic, but you do need to know the order. A memory sentence helps: Raging Martians Invaded Venus Using X-ray Guns.

Wavelength, Frequency, and Energy

  • Wavelength (λ): the distance from one peak of a wave to the next.
  • Frequency: how many waves pass a point each second.
  • All light travels at the same speed, so shorter λ → higher frequency.
  • Higher frequency → more energy per photon, a single packet of light energy.
Two waves. Top: a red wave with a long wavelength, labeled long wavelength, low energy. Bottom: a purple wave with a short wavelength, labeled short wavelength, high energy.

Remember the chain: short wavelength, high frequency, high energy. Topic 3.12 puts numbers on this pattern with equations.

Visible Light

  • Visible light runs from about 700 nm (red) to about 400 nm (violet).
  • Red has the longest λ and the lowest energy of the visible colors.
  • Violet has the shortest λ and the highest energy.
The visible spectrum from red at 700 nm on the left to violet at 400 nm on the right, with an arrow showing energy increasing toward violet.

Just past violet is ultraviolet, which carries even more energy. That is why UV light can cause a sunburn and red light cannot.

Absorption and Emission

  • Atoms and molecules can only have certain energy levels.
  • Absorption: a particle absorbs a photon and moves up to a higher energy level.
  • Emission: a particle drops to a lower energy level and gives off a photon.
Two energy level diagrams. Absorption: a photon comes in and an arrow points up from the lower level to the higher level, a gap labeled delta E. Emission: an arrow points down from the higher level to the lower level and a photon leaves.

The energy of the photon must match the gap between the two levels, ΔE. A photon that does not match a gap is not absorbed; it passes right through. That is why each substance absorbs only certain wavelengths, and it is what makes spectroscopy useful.

Microwaves: Rotation

  • Microwave photons change a molecule’s rotational energy level.
  • After absorbing a microwave photon, the molecule rotates faster.
  • Rotational levels are very close together, so low-energy microwaves are enough.
A microwave photon approaches an HCl molecule, shown as a small H atom bonded to a larger Cl atom, with curved arrows around it showing rotation.

Infrared: Vibration

  • Infrared photons change a molecule’s vibrational energy level.
  • Think of a bond as a spring: after absorbing an infrared photon, it stretches and compresses with more energy.
  • In molecules with three or more atoms, bonds can also bend.
An infrared photon approaches an HCl molecule. The H-Cl bond is drawn as a spring, with double-headed arrows on each atom showing the bond stretching and compressing.

Different bonds absorb different wavelengths of infrared light, so infrared spectroscopy is used to identify the bonds in a molecule. Carbon dioxide absorbs infrared light given off by Earth’s surface, which is a big part of the greenhouse effect.

UV/Visible: Electronic Transitions

  • Ultraviolet and visible photons have enough energy to move an electron to a higher energy level.
  • This is called an electronic transition.
  • The gaps between electron energy levels are much larger than the gaps for rotation or vibration.
A UV or visible photon approaches an atom. An electron on the inner energy level jumps, shown by a dashed arrow, to an outer, higher energy level.

This is also why many solutions are colored. When a substance absorbs some colors of visible light, the colors left over are the ones we see.

Matching Light to Molecular Change

Chart matching each region to its molecular change: microwave to rotation, infrared to vibration, UV/visible to electronic transition. A downward arrow on the left shows energy increasing from microwave to UV/visible.
RegionPhoton energyChange in the moleculeMemory word
MicrowaveLowestRotational energy increasesSpin
InfraredMiddleVibrational energy increasesShake
UV/visibleHighestElectron moves to a higher energy levelJump

As photon energy increases, so does the size of the energy gap it can match: rotational gaps are the smallest, vibrational gaps are in the middle, and electronic gaps are the largest. On the AP exam, you may be given a region and asked what it does to a molecule, or told what happened to a molecule and asked which region caused it.

↑ Back to top


Worked Examples

Try each problem on your own first, then open the solution to check your work.

Example 1: Ranking Photon Energy

Rank these photons from lowest to highest energy: ultraviolet, microwave, visible, infrared.

Show the solution
  1. Recall the order of the spectrum: radio < microwave < infrared < visible < ultraviolet < X-ray < gamma, from low energy to high energy.
  2. Put the four photons in that order: keep only the four given, in the same order.
  3. Check with wavelength: microwaves have the longest λ of the four and ultraviolet has the shortest. Shorter λ means higher energy, so the order checks out.
  4. Answer: microwave < infrared < visible < ultraviolet

Example 2: What Happens to HCl?

A sample of HCl gas absorbs infrared radiation. Describe what happens to the HCl molecules. Justify your answer.

Show the solution
  1. Identify the region: infrared. Infrared photons cause changes in vibrational energy levels.
  2. Describe the change: the HCl molecules move to a higher vibrational energy level. The H-Cl bond stretches and compresses with more energy.
  3. Justify: the energy of each infrared photon matches the energy gap between two vibrational levels in HCl, so the photon is absorbed.
  4. Answer: The vibrational energy of the HCl molecules increases. The infrared photon energy matches the gap between vibrational levels.

Watch out: do not say the electrons are excited. Infrared photons do not carry enough energy for an electronic transition.

Example 3: Evaluate the Claim

A student claims that microwave radiation can excite electrons in water molecules to higher energy levels. Do you agree or disagree? Justify your answer.

Show the solution
  1. Identify what microwaves do: microwave photons change rotational energy levels. They make molecules rotate faster.
  2. Identify what exciting electrons requires: ultraviolet or visible photons, which have much more energy than microwave photons.
  3. Compare the energy gaps: electronic gaps are much larger than rotational gaps, so a microwave photon’s energy cannot match them.
  4. Answer: Disagree. Microwave photons only have enough energy to change the rotational energy of water molecules. Exciting electrons requires higher-energy UV or visible photons.

Example 4: Identifying the Region

A molecule absorbs a photon. Afterward, its rotational energy has increased, but its vibrational and electronic energy have not changed. Which region of the electromagnetic spectrum did the photon most likely come from? Explain.

Show the solution
  1. Identify the change: only the rotational energy level changed.
  2. Match the change to a region: rotational transitions are caused by microwave radiation.
  3. Rule out the others: an infrared photon would change the vibrational level, and a UV or visible photon would cause an electronic transition.
  4. Answer: Microwave. Rotational energy gaps are the smallest, and microwave photons have the right amount of energy to match them.

↑ Back to top


Practice

Practice with instant feedback

Answer original AP-style questions for Unit 3 and see an explanation right after each one. Choose Topic 3.11 or mix topics. No login needed.

↑ Back to top


Lesson Slides

↑ Back to top


Big Ideas

  • Spectroscopy is the study of how matter absorbs or emits light.
  • Shorter wavelength → higher frequency → higher energy.
  • A photon is absorbed only when its energy matches a gap between energy levels (ΔE).
  • Microwave → rotation, infrared → vibration, UV/visible → electronic transitions.

Exam tip: on free-response questions, name the specific type of transition (rotational, vibrational, or electronic) and connect it to the photon’s energy. Saying the molecule “gets excited” is not enough.

Back to the essential question: the type of light a molecule absorbs tells us what kind of change happened inside it, whether it spins, shakes, or has an electron jump. Next up, Topic 3.12 uses c = λν and E = hν to calculate the energy of a photon.

↑ Back to top


AP Alignment

This lesson covers Topic 3.11, Spectroscopy and the Electromagnetic Spectrum, in Unit 3 (Properties of Substances and Mixtures) of the College Board AP Chemistry Course and Exam Description (CED). Learning objective:

  • 3.11.A: Explain the relationship between a region of the electromagnetic spectrum and the types of molecular or electronic transitions associated with that region.

Essential knowledge: 3.11.A.1

Suggested skill: 4.A Model Analysis. Predict and/or explain chemical properties or phenomena (e.g., of atoms or molecules) using given chemical theories, models, and representations.

↑ Back to top